CORVON RID-A0 Remote ID Broadcast Module

The CORVON RID-A0 is an add-on Remote ID broadcast module. Stick it to the airframe and run one cable to the flight controller: the module takes the aircraft's identification and position from the flight controller and broadcasts them over Bluetooth. Works with ArduPilot and PX4 flight controllers.

• Add-on design: no flight-controller firmware or airframe changes; 3M adhesive and one GH1.25 cable
• DroneCAN over CAN or MAVLink over UART, with both cables in the box
• Broadcasting starts at power-on, no ground-station command needed
• Bluetooth 5 Long Range plus Bluetooth 4 broadcast
• Configure from a phone browser through the built-in Wi-Fi page; no app or driver
• One-time identity lock: the ID becomes read-only
• Signed OTA firmware updates
• 11.2 g in a 38 × 23.5 × 9 mm CNC aluminum enclosure

Choose the US or EU variant: the broadcast mode is preset at the factory to match.

Key specs: Processor: ESP32-C3 (RISC-V, 160 MHz) Wireless: Bluetooth 5.0 incl. Long Range (Coded PHY) · Wi-Fi 802.11 b/g/n (configuration only) Band: 2.4 GHz (2402–2480 MHz) Broadcast rate (factory default): Bluetooth 5 Long Range 2 Hz + Bluetooth 4 full message set 1 Hz Interfaces: 2 × GH1.25 4-pin (CAN / UART) · USB-C · MMCX antenna port Supply: 5 V Serial number: ANSI/CTA-2063-A Antenna: external RID-ANT-01, MMCX, 300 mm cable Size & weight: 38 × 23.5 × 9 mm · 11.2 g (without antenna) Compatible flight controllers: ArduPilot · PX4

In the box: 1× RID-A0 module 1× CAN cable 1× UART cable 1× RID-ANT-01 external antenna (300 mm cable, MMCX)

Full pinout, LED codes and antenna placement: see the spec sheet on this page.